DIG Corp., LEIT: Programming Problems: LEIT-2 & LEIT RC2 Support

Programming Quick Reference Chart can be downloaded from LEIT-2 System Instruction Manuals

The Rain Stop is Active. To reactivate the program schedule after connection is established, go into the Setup menu select the Rain Stop icon and cancel the rain stop by setting it to "00".
Check the date and time on the controller to make sure that it is the same as the handset.
No programming schedules have been entered yet. In controller Menu, select Program icon and setup a schedule within Program A or B.
The programmed runtime of the stations is set to "0" duration. After connection is established, in controller Menu, select Program icon and alter your runtime within Program A or B.
A sensor is hooked up to the system that is inhibiting irrigation or sensor wires are not connected if sensor added.
The Month stop feature is turned on inhibiting irrigation for that entire month. In controller Menu, select Setup icon and in the Setup menu select the month off icon and make sure the current month is set to active.
If a program runs but starts unexpectedly check the schedule settings. If a new program starts before the old program has completed it will be stacked commence later.
Make sure there is enough time between the programs and/or start times to meet your watering time in budget (up to 200% possible

Check that the controller PVM (solar) panel is not covered. If it has been covered for an extended period, the controller time will reset.
Check to see if the correct Client ID & Control ID has been programmed into the Leit Rc2 handset, the Client ID & Control ID on the handset must be the same Client ID & Control ID as programmed into the controller for communication to be established.
Communication with the Leit-2 controller will only initiate when the controller is fully charged. It takes approximately 2 hours to charge the Leit-2 controller in shaded conditions and approximately 30 minutes to charge the Leit-2 controller in sunny conditions.