LEIT XRC
The Independent, Preferred Power Irrigation Solution
The LEIT XRC Controller is a programmable, self contained, water management irrigation control system. It can be programmed to control up to 28 zones using the 1600HE solenoid, spanning an area of over one mile with up to 12 independent water schedules per valve. The LEIT XRC controllers can be installed in any location in an open un-shaded area.
How much light is needed?
The LEIT controllers are unique to all other water management and irrigation control systems because of their ability to harness ambient light to generate electricity. The electricity is stored in long life non-battery based super capacitors and used to power the controller. This feature allows the LEIT system to operate in most area, in any weather conditions, 7 days a week, 24 hours a day. On a normal day with direct sunlight, an average range of 5,000 - 100,000 lux can be measured. The LEIT XRC controller requires a minimum of 10,000 lux for normal operation.
Combine the advanced programming capability of the LEIT XRC controller with the advantages of solar power and it is obvious why the LEIT XRC is the top choice for today's irrigation needs.
The LEIT XRC controller can be used as an individual controller or as a key component of the LEIT Link® irrigation management system. The LEIT XRC series utilizes two-way radio communication to correspond with a LEIT Link Remote Control Handset. The XRC incorporates all the features of the earlier models of LEIT and many new features, allowing the user a wide range of flexibility using two-way communication without the requirement of AC power. The LEIT XRC requires sufficient power for radio operation and should be located in an open un-shaded location.
Made in California, U.S.A.
Features:
- Operates drip or sprinkler systems
- Remote programming and management capability from LEIT Link Remote Control Handset
- Remote control protocol allows LEIT XRC to communicate with more than one LEIT Link Remote Control Handset
- LEIT XRC radio frequency module operates in the ISM band 900-928 MHz US and Australia (866 MHz Europe)
- Operates 4, 6, 8, 10, 12, 16, 20, 24 and 28 stations plus a master valve or pump start, without AC power hookup, batteries or conventional solar panels
- Terminal strip can handle 28 hot wire stations, an MV/P wire and 2 common wires
- Non-volatile memory holds programs indefinitely without batteries
- Liquid crystal display is easy to read under almost any daylight conditions
- Programming is easy, using a self-guided menu and four durable, sealed buttons
- Bilingual software in English, Spanish and Italian
- Functions day or night in any weather and most outdoor locations
- All power is provided by an internal, photovoltaic module and Microelectronic energy management system fueled by ambient light
- Built to the highest quality control standard (ISO 9002)
- Controller functions and operations are 100% tested *Waterproofing 100% tested
- Lightning protection, the controller is fully isolated from electrical ground, offering virtual immunity to ground currents from overhead power lines and/or close proximity to lightning strikes
- Simple to install, easy access wire connector accommodates standard irrigation wire up to 12 gauge
- Environmentally friendly, uses clean power
- Assign rain, moisture or freeze sensors to an individual valve or to the entire system using the SKIT 8821-4 adapter
Programming Features:
- Watering durations from 1 minute to 5 hours and 59 minutes
- 4 programs with 3-start times per program allow for mixed irrigation applications
- Custom programming with 7-day calendar or interval of 1-39 days in odd/even or every day rotation x• Status report provides information on active programs or valve, months deactivation, rain stop, remote or local mode, and station short circuit if used with LEMA 1600HE only
- Rain delay up to 99 days with auto-restart
- Individual monthly water budgeting from 10- 200% in 10% increments
- Custom grouping of stations allows the controller to operate more than one group and any number of stations per group together (if hydraulic limitations are not exceeded)
- Manual run allows for repeat testing of individual valves, semi-automatic cycle by station with quick override via manual setup, skip to the next valve or run any of the programs
- History reports allow the user to review the controller operating history for a total watering time of each valve with overall total and manual run time. This information is available for the current month and the previous 11 months. The user can also review the current year versus previous year.
- Monthly off option allows shut-off of irrigation for any month of the year. All the months are active by default.
- Open or short wire circuit allows the controller to detect shorts and/or open wires. The Short and Open valve test is deactivated by default.
Electrical Specifications:
- Controller Input: 0-100,000+ lux. Normal operation requires average of 10,000 lux
- Controller Output: 5-volt pulse
- Remote Handset Input: 12-volts using 3.6-volt Nim/MH
Security:
- Programming password eliminates potential error by another user
- Password can be changed at any time during program setup
- Standard stainless steel lock secures weather resistant exterior panel
Mechanical Specifications:
- Unit mounts securely to a rugged galvanized steel mounting column using stainless steel lock bolts
- Vandal resistant, waterproof enclosure fashioned from super tough material endures extreme hot, cold, wet or dry weather
- Super-tough LEXAN© lens protects the photovoltaic module from moisture, dust, chemicals and impact damage
- Weight: 4.9 lbs (2.2 kg)
- Operational Temperature: 14-140°F (–10- 60°C)
Dimensions:
- 12" H x 7.5" W x 4.5" D (30.4 cm H x 19 cm W x 11.4 cm D)
back